Tetrafluoroethylene cutting plate and PTFE board One of the obvious differences between them is that their processing technology is different. teflon The cutting board is made of polytetrafluoroethylene epoxy resin rubber and plastic insulation board, which is burned and then turned into a commodity, while the polytetrafluoroethylene rubber and plastic insulation board is formed at room temperature, and then burned and cooled. In addition to the difference in processing technology Molded plate There is also a difference in the middle, that is, their thickness is different, that is, the thickness of the PTFE cutting plate is 0.5mm-8mm, while the thickness of the PTFE rubber plastic insulation plate is 5mm-50mm.
Teflon plate There are various construction methods and many construction regulations in the specific construction process. In the construction steps of tetrafluoro plate, construction is not allowed when the working temperature is less than 5 ℃; If the wind above level 5 is strong, the construction cannot be carried out. The protective layer shall be prepared immediately after construction, and different measures shall be taken to avoid exposure. In the process of construction of PTFE board, in case of precipitation, relevant measures shall be taken to avoid precipitation washing. In winter, cold prevention shall be carried out according to relevant specifications.
During the construction of tetrafluoro products, construction workers should wear relevant labor protection articles, take safety precautions, and ensure that all workers are technically professional and have passed the job training. During the construction process, the tetrafluoro plate should be immediately fixed by pasting or steel bar anchoring to prevent the surface from falling, so that the construction of the decorative design surface can be carried out more quickly. At the same time, in all construction steps, the configuration should be carried out according to the design concept of the commodity, so as to prevent the immediate direct sunlight, And any fixed work shall be carried out within two hours.
